Dollhouse: Getting Closer to Being Done

I seem to spend more time on the dollhouse rather then writing about the work being done. Much of the work seems pretty routine and, well, obvious, so I am not writing about everything I do. If you ever have questions about something that I’ve done, please ask and I will elaborate. Sometimes what seems straightforward to me is confusing to someone else. And vice-versa.

So much of the work done over the past couple of weeks has been about getting the basics done so the furniture can go in. Of course, the kitchen is primarily “basic”, so a lot of work has been done there. I’ve also done a lot of prep for the doors, floors and trim. I can see the light at the end of this tunnel!IMG_4078The greatest amount of work (and fun!) was the kitchen. I had ordered all of the cabinetry in kits, that is, I had to assemble it all. To make sure it all fit correctly, I made templates for both the walls and floor so that it would fit in like a puzzle.

I used pieces of laminate that I had ordered from Wilson (ordering info further down the page). The way it worked out, that back piece acted as a “plate” that the cabinets could be glued to and then placed into the house. And as a bonus, it became the backsplash, a jaunty little fiftie’s motif in red, white and turquoise.

IMG_4102This was the short “stove” wall… The Kid created the range hood from stainless steel. Initially it was a little short, so I added the little cap at the top.DSCN4896A shot of the long wall with kitchen sink and ‘fridge. I still had to cut the section for the window.IMG_9853The floor is actually another pattern of laminate sample. The only issue I had working with it was weighting the flooring down as it dried. You can kind of get the sense of the air pocket under the floor in the photo above.

IMG_4125With much of the dollhouse complete, I finally moved it off the kitchen island back in front of the fireplace. Much of the window treatments are done, furniture found and purchased, and lots of little details being worked on.

One thing I goofed on was adding the baseboards before installing the doors. I was waiting on the purchased hardware to arrive and just got ahead of myself. Now that it has arrived (and changed from brass to silver finish), I’ve prepared all the doors for installation. I think this is going to be a bigger deal that it should, considering that I think I will need to trim the baseboards to fit the doors.IMG_4124Larger than most starter dollhouses, it requires quite a few doors (and the two IMG_4123inside/outside doors are already installed)! Here I was adding the door knobs. As I mentioned, the pre-purchased door handles were all brass colored. Laying them onto a sheet of poster board and securing them for painting with a glue stick.

You can also see a few of the miniature trivets that I purchased off the internet. Since the kitchen is red and white with a pop of turquoise, some of the trivets had to be sprayed painted.IMG_4128

The doors between the dining room and kitchen were designed to open together, instead of knobs, I made push plates. I cut these from metal-look laminate as well. I had several selections to choose from, here are a couple of the sample tiles.

They really look like metal!

While I was at it, I cut kick plates for the front door as well (to be installed at a later date).IMG_4126Things are progressing and am quite close to adding the details. And then a gigantic photo shoot will occur to show off the whole thing.

Down the road a little ways, I am planning to add clear plexiglass doors to keep the house from getting dusty. Initially I thought I wanted to finish it and then never touch it again, but instead of a single sheet on the back of the house, I decided to construct two larger doors for adjustments or so new items can be added. I am also going to place a clear “wall” onto the back of the boys’ room.

When I started the project of completing this dollhouse, I vowed to work on nothing else so as to not distract me from the task at hand. I have a little bit of crafting ADHD and tend to easily get drawn into other projects and consequently end up with a lot of unfinished projects. Now it seems that I should be finishing up the house at about the same time I will be going back to work! I will work furiously to get all the little details written about in the next couple of weeks.

And please! I love to share my projects and the way I went about doing things. But I love to hear from others as well… comments and questions are the icing on the creative cake!

julie

About MacCupcake

Obviously, a big Mac fan (my first Mac was the first Mac) and mother to the most awesome kid in the world. A techno-junkie and self-proclaimed geek... I love anything and everything relating to computers. Also love making things and figuring out how to make or adapt existing stuff into something new! Always ready to try something new!

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: